Skip to main content
Metro Brick & Stone Co.
How to set it

Brick installation tips.

A few things we’ve learned setting reclaimed and thin brick: how to pick the face, wash it, blend the color, and get clean cuts. Watch the walkthrough, then work down the list before you start.

Before you set a single brick

5 steps that make the difference between a wall that reads as one material and one that looks like two orders.

  1. Pick which face goes out

    The fired clay face carries the character: color variation, and often a sandy texture. The sawn side is the cut back, and it is very smooth. For the textured look, set the sawn side against the surface so the fired face shows. Used brick may also carry old mortar or paint, so decide how much of that you want before you commit.

  2. Wash the brick on both sides

    Even after cutting and rinsing, there's usually some dust left on the brick. Clean both faces so the mortar bonds properly.

  3. Pull from several sleeves or pallets

    For a blended look, work out of a few bundles at once as you go rather than emptying one before opening the next.

  4. Lay out your pattern on the floor first

    Set the brick out on the ground in the pattern you want to see, and arrange the colors until the blend looks right before anything goes on the wall.

  5. Use broken pieces for end cuts and corners

    Reclaimed brick includes some breakage. Those pieces are typically still perfect for cuts and trim, and we include extra to account for it.

Why brick

Made to outlast the building

A couple of short films on why we quarry, salvage, and cut the way we do.

Working out how much you need?

Coverage rates by brick size, mortar and sand math, and the disclaimers that go with an estimate.

Material estimating